5 command interpreter mode, 6 call control – ZyXEL Communications Prestige 480 User Manual
Page 193
Prestige 480 Dual BRI ISDN Router
System Maintenance
13-17
13.5 Command Interpreter Mode
This option allows you to enter the command interpreter mode(CI). A list of valid commands can be found
by typing [help] at the command prompt. For more detailed information, check your PNC installation disc or
visit the ZyXEL Web site or send e-mail to the ZyXEL Support Group.
Figure 13-13 Command Mode
13.6 Call Control
The Prestige provides four call control functions: call control parameters, blacklist, budget management and
call history.
Call control parameters allows you to set a dial out time limit, the number of times a number should be called
before it is added to the blacklist and the interim between calls.
The budget management function allows you to set a limit on the total outgoing call time of the Prestige over
a period of time. When the total outgoing call time exceeds the limit, the current call will be dropped and any
future outgoing calls will be blocked.
The blacklist function prevents the Prestige from re-dialing to an unreachable phone number. It is a list of
phone numbers, up to a maximum of 14, to which the Prestige will not make an outgoing call. If the Prestige
tries to dial to a phone number and fails a certain number of times (configurable in Menu 24.9.1), then the
Enter Menu Selection Number: 8
Copyright (c) 1994 - 1999 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit ether isdn
ip