Zanussi ZYB 460 - Manual (Page 14)

During pyrolytic cleaning the light does not operate.
When the oven is at the set temperature, the door
locks.
The bars of the heat indicator come up, until the door un-
locks again.
Pyro reminder
The reminder function tells the user when pyrolytic clean-
ing is necessary.
An acoustic signal sounds and the display shows "Pyro"
for approximately 15 seconds.
Set the Pyrolytic cleaning function.
The display shows the reminder message when the
appliance is off until you clean the appliance with
the Pyrolytic cleaning.
Cleaning the oven door
The oven door has three panels of glass. You can remove
the oven door and the internal panels of glass to clean
them.
The oven door can close if you try to remove the
panels of glass before you remove the oven door.
Removing the oven door and the glass panel
1 Open the door fully
and hold the two door
hinges.
2 Lift and turn the levers
on the two hinges.
3 Close the oven door
to the first opening posi-
tion (halfway). Then pull
forward and remove the
door from its seat.
4 Put the door on a soft
cloth on a stable surface.
5 Release the locking
system to remove the
panels of glass.
90°
6 Turn the two fasteners
by 90° and remove them
from their seats.
2
1
7 Carefully lift (step 1)
and remove (step 2) the
panels of glass one by
one. Start from the top
panel of glass.
Clean the glass panels with water and soap. Dry the glass
panels carefully
Installing the door and the glass panels
When the cleaning is completed, install the glass panels
and the oven door. Do the above steps in the opposite se-
quence.
The middle panel has a decorative frame. When you install
this panel, make sure that the screen-printing zone looks
14