Zebra Technologies LP 2844 - Manual (Page 25)

Adjusting the Print Width
Print width must be calibrated when you use a roll with a different width
from previous media.
Print width may be set by using the Set Label Width ( Q ) command
(described in the programming guide).
Adjusting the Print Quality
Print quality is influenced by the heat of the print head, the speed of the
media and the type of media you are using. Only by experimenting will
you find the optimal mix for your application.
If you find that the print darkness needs to be adjusted, refer to the heat
density (
D ) command (described in the programming guide).
If you find that the print speed needs to be adjusted, refer to the print speed
(
S ) command (described in the programming guide).
980483-001A 17