X10 Wireless Technology MK19A - Manual (Page 21)

41 40
If you have installed the Transceiver
Module (sold separately) you can control
it and other X-10 modules as follows:
1. Press and release
the X-10 button.
2. Use the number
buttons to enter the
Unit Code number
of the chosen
module. (You do
not need to enter
‘0’ first for a single
digit number.)
3. Press the appro-
priate button for the
function you require
(see below).
X-10 FUNCTIONS:
On: CHANNEL +
Off: CHANNEL –
Bright: VOLUME +
Dim: VOLUME –
All Lights On: POWER
All Modules Off: MUTE
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
C
ONTROLLING
X-10
M
ODULES
L
AMP
M
ODULE
The Lamp Module (sold separately) may
be used to control any incandescent
lamp rated up to 300W. It is not suitable
for other types of lamps such as
fluorescent or energy saving lamps, or
lamps which include a dimmer control.
Caution: Do not connect an appliance
such as a coffee pot or heater to the
Lamp Module. It may damage the
Module and the appliance and could
cause a fire hazard.
1. Set the House Code
to ‘A’ and the Unit
Code to ‘2.’
2. Plug a lamp into
the Lamp Module.
3. Plug the Lamp
Module into a
convenient AC
outlet.