Znyx Networks ZX4300P - Manual (Page 16)

Connector Pinouts
ZX4300P Series User's Guide Page 13
Notes for J Connector Pinouts from Previous Tables
Sections referenced below pertain to the CompactPCI Packet Switching Backplane PICMG 2.16
Draft 0.6.5 June 19, 2001
1. BP(I/O) connects Front card to Rear card and does not connect to backplane. Refer to
Section 3.1.1.2 for Alternate Node Board Keying Compliance.
2. GND for Type B style J3 connector.
3. Refer to Sections 3.3.2.3, 3.3.3.7, 3.3.5.1, 3.3.6.1, 4.3.5, 4.3.6, 4.4.1, and 4.4.10.
4. Refer to Sections 3.3.3.8, 3.3.6.2, 4.3.7, 4.4.1, 4.4.9, and 4.4.10.
5. Refer to Sections 4.3.6 and 4.4.5.
6. Refer to Section 4.4.6.
7. Refer to the PICMG 2.0 Rev 3.0 CompactPCI Specification.
8. Required as per PICMG 2.0 Rev 3.0 CompactPCI Specification.
9. Refer to Sections 3.3.1.4 and 3.3.4.3.
10. Refer to Section 3.5.1.3.
11. Refer to Sections 3.3.1.1, 3.3.4.1, and 4.4.2.
12. Refer to Sections 3.3.1.3 and 4.3.4.
13. Refer to Sections 3.3.1.5 and 4.3.1.
14. In accordance with PICMG 2.1 R2.0.
15. Refer to Sections 3.5.1.1 and 3.5.2.1.
16. Signal edge rate shall not exceed 6.4 V/ns. Refer to Section 4.4.10.
17. Signal edge rate shall not exceed 12.8 V/ns. Refer to Section 4.4.10.
18. Refer to Sections 3.3.1.7 and 3.3.4.5.