Znyx Networks ZX4300P - Manual (Page 7)

Installation
ZX4300P Series User's Guide Page 4
Installing the Rear Transition Board (RTB)
1. Remove the slot cover (or covers) from the corresponding rear panel bracket (slot filler) on
your system.
2. Insert the correct Rear Transition Board into the slot.
NOTE: Exercise extreme care when inserting the RTB card into the chassis. Improper
alignment of the rear transition card connector with the rear panel connector pins can
damage the pins. Your switch includes AB connectors to assist in properly aligning the
RTB for insertion. Follow the same insertion precautions as the switch.
3. Push the extraction levers towards one another to finish seating the RTB and secure the
retention screws.