Chapter 2 - installing the yamaha cdr200t drive – Yamaha CDR200t User Manual
Page 13
Chapter 2 - Installing the Yamaha CDR200t Drive
7
♦
Parity setting
Parity ON
(with a jumper)
— Parity Check will be performed.
Normally, use this setting.
Parity OFF
(without a jumper)
— Parity Check will not be performed.
♦
Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON
(with a jumper)
— Use this setting if the CDR200t is the last device in the internal
SCSI daisy-chain.
Terminator OFF
(without a jumper)
— Use this setting if devices other than the CDR200t are in the inter-
nal SCSI daisy-chain and the CDR200t is not the last device.
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Parity ON
Parity OFF
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Terminator ON
Terminator OFF