Yamaha CDR200t - Manual (Page 15)

Chapter 2 - Installing the Yamaha CDR200t Drive
9
Audio output cable
Connect an audio output cable to the AUDIO OUT connector in the
lower left corner of the rear panel.
Make sure that the projection of the connector is facing upward.
DC power cable
Connect a DC power cable to the DC INPUT connector on the lower
right corner of the rear panel.
Make sure that the notch on the connector is facing upward .
R G
L
AUDIO OUT 1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SER. NO.
SCSI INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V
R G
L
AUDIO OUT 1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SER. NO.
SCSI INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V