Yamaha EMX68s - Manual (Page 18)

16
Front and rear panel
EMX88S/EMX68S—Owner’s Manual
Rear panel
1 Speaker output jacks (SPEAKERS)
Connect speakers here. The EMX88S/EMX68S
has two internal power amps. There are three
ways in which speakers can be connected to the
EMX88S/EMX68S.
• Two-channel connection
• Two-channel parallel connection
• Bridge connection
At this time, use the power amp select switch N
on the control panel to select a signal sent to the
correct jacks.
Refer to the “Connections” section on the next
page.
2 AC IN socket
Connect the included power cord to this socket.
Connect the plug of the power cord to an AC out-
let that meets the requirements stated in the spec-
ifications in this document.
Installation
The EMX88S/EMX68S uses a forced cooling system with intake on the bottom of the rear panel and exhaust
on the top of the rear panel to avoid blocking the heated air flow.
2 1
NO
NO
Front
Front
15cm
or less
Exhaust
Intake