Zebra Technologies 2844 Printer - Manual (Page 28)

Using the Cutter Option
Printers that have a bezel with a motorized blade can dispense one or more
forms that are then automatically cut from the media supply. This option
cuts through continuous paper from rolls and liner between labels. Keep
the cutter dry. Never use any solutions or solvents to clean the blade.
Use the f command to set the cut position and the C command to cut
immediately outside a form.
If the blade cuts through labels, adhesive
can jam the cutter.
1. Turn OFF (O) printer power and
unplug the power and interface cables
before clearing the cutter.
2. After removing debris, plug in the
power and interface cables, turn on
the printer, then test for normal
operation.
980483-001A 23
H-970
PAGE 28 OF 47 0808 IH-970