Zap JACKSHAFT MOTOR-CONTROL SYSTEM 815-RL - Manual (Page 13)

be strapped to the Super-Drive Bowden cable with
cable ties to allow both cables to seat neatly in the
slot in the bottom of the Motor Cover. (Pic 20)
Do not cut or shorten the Motor Cable. Ensure
that any unused cable is coiled and secured away
from any moving parts, using the cable ties
provided.
NOTE THAT ALL TERMINALS ARE PLUG-IN FOR
EASE OF WIRING and that all terminal functions
are labelled on the panel.
FITTING THE MOTOR COVER KIT
The kit includes a front and back cover section.
The cover front has two clips, which clip over the
motor barrel.
Position the cover front with the clips resting on
the motor barrel. Then firmly push the cover with
a hand over the cover clip positions to ensure that
the clips are seated in position over the motor
barrel. (Pic 21)
The upper two pegs in the top edge of the cover
back are next located in the two holes in the top
edge of the cover front. (Pic 22).
Seat the cover back in the recess of the front
cover and fit the 2 bottom screws and at least
one of the side screws provided. (Pic 23 overleaf)
8
Pic 20
Pic 21
Pic 22