Zap JACKSHAFT MOTOR-CONTROL SYSTEM 815-RL - Manual (Page 23)

AUTO-CLOSE TIMER
PROGRAMMING
This function is not available for the North American
market.
The factory set Auto-Close timer delay is 15 seconds.
In order to confirm the operation of the Auto-
Close timer first set DIP switch No. 4 to ON. Then
press the case push button to open the door. The
door will open and re-close after the time delay.
The factory preset time delay is 15 seconds.
To change the Auto-Close time delay proceed as
follows:
1. Close the door.
2. Set DIP switch No. 4 to the ON position.
3. Press and hold the program button.
4. Release the button after the SECOND flash or
beep.
5. Press the OPEN push button.
6. After the door has fully opened and after the
required delay press the CLOSE push button.
This new delay will now be stored into the
memory and retained during any power
interruptions.
A sequence of 6 flashes and beeps follow to
prompt you to decide if you want the door to
Auto-Close regardless of the door re-opening
after striking an obstruction.
It is preferable that the door should re-open and
stay open following an obstruction strike.
However it may be required for security reasons
that the door should Auto-Close after re-opening,
after hitting a large build-up of snow and ice in
winter, in which case it will make two attempts to
close onto the ice. If the snow and ice has not
compressed then on the third run it will then stop
on the ice.
If the door is required to Auto-Close regardless of
such an obstruction then press the close button a
second time during the 6 flashes and bleeps.
If the CLOSE button is not pressed during the
flashes and beeps the controller will default to
stay open after an obstruction re-open sequence.
If it is required to change the programmed delay
then repeat the programming sequence.
If a Zap Radio Remote Control system is fitted and
the Auto-Close function is enabled then operation
of the transmitter will only open the door. The
door will close after the programmed time delay.
Whilst the door is open, the close delay is reset
each time the Zap transmitter is operated and
each time a safety circuit or Photo-Eye is activated.
18


 8
  
 
 









ZAP 800-R CONTROLLER WIRING
ACCESSORY RADIO – PULSE OPERATION