2 nat setup, Figure 315 menu 15: nat setup, Table 214 applying nat in menus 4 & 11.1.2 – ZyXEL Communications Internet Security Appliance ZyWALL5UTM 4.0 User Manual
Page 560
ZyWALL 5/35/70 Series User’s Guide
Chapter 42 Network Address Translation (NAT)
560
The following table describes the fields in this menu.
Table 214 Applying NAT in Menus 4 & 11.1.2
FIELD
DESCRIPTION
OPTIONS
Network
Address
Translation
When you select this option the SMT will use Address Mapping Set 1
(menu 15.1 - see
for further discussion). You
can configure any of the mapping types described in
. Choose Full Feature if you have multiple public WAN IP addresses
for your ZyWALL.
When you select Full Feature you must configure at least one address
mapping set.
Full Feature
NAT is disabled when you select this option.
None
When you select this option the SMT will use Address Mapping Set 255
(menu 15.1 - see
). Choose SUA Only if you
have just one public WAN IP address for your ZyWALL.
SUA Only
42.2 NAT Setup
Use the address mapping sets menus and submenus to create the mapping table used to assign
global addresses to computers on the LAN and the DMZ. Set 255 is used for SUA. When you
select Full Feature in menu 4, menu 11.1.2 or menu 11.2.2, the SMT will use Set 1 for the
first WAN port and Set 2 for the second WAN port. When you select SUA Only, the SMT
will use the pre-configured Set 255 (read only).
The server set is a list of LAN and DMZ servers mapped to external ports. To use this set, a
server rule must be set up inside the NAT address mapping set. Please see the section on port
forwarding in
for further information on these menus. To configure
NAT, enter 15 from the main menu to bring up the following screen.
Note: On a ZyWALL with two WAN ports, you can configure port forwarding and
trigger port rules for the first WAN port and separate sets of rules for the
second WAN port.
Figure 315 Menu 15: NAT Setup
Menu 15 - NAT Setup
1. Address Mapping Sets
2. Port Forwarding Setup
3. Trigger Port Setup
Enter Menu Selection Number:
Note: Configure DMZ, WLAN and LAN IP addresses in NAT menus 15.1 and 15.2.
DMZ, WLAN and LAN IP addresses must be on separate subnets.