Zoom MRS-1266 - Manual (Page 123)

Reference [Effects]
ZOOM MRS-1266
123
N OTE
Some effect modules have only one effect type. For such
modules, there will be no screen for selecting the effect type.
6.
Use the cursor up/down keys to select the effect
parameter that you want to edit.
The following diagram shows an example of what appears
on the display when you have selected the DEPTH
parameter of the “FLANGER” effect.
7.
Turn the dial to change the setting.
For details on the effect types that can be selected for each
effect module, and on the effect parameters of each type,
refer to the appendix ( → p. 164) at the end of this manual.
8.
Repeat steps 4 - 7 to make the desired edits for
other modules.
9.
If you want to adjust the patch level (the final
volume of the patch), press the [TOTAL] key, use
the cursor up/down keys to bring up the indication
“TOTAL PAT LVL”, and turn the dial.
The patch level can be adjusted in a range of 1 - 30.
10.
When you have finished editing, press the [EXIT]
key.
The unit returns to the patch select screen.
N OTE
Keep in mind that if you return to the patch select screen and
select another patch without first storing the patch, the
edited contents will be lost. If you want to keep the results of
your editing, refer to the following section.
Storing an insert effect patch
A patch that you have edited can be stored in any location of
the same algorithm. You can also store an existing patch in
another location to create a copy of that patch.
1.
Press the [EFFECT] key in the display section, and
then press the [EDIT] key.
The currently selected patch can now be edited. Perform any
editing steps that you wish to make.
2.
When editing is complete, press the [STORE] key in
the control section.
A screen for specifying the store target location appears on
the display.
3.
Turn the dial to select the store destination patch
number.
4.
To execute the store process, press the [STORE]
key once more.
The patch will be stored, and the unit returns to the patch
select screen.
H INT
• Patches that you have stored are saved on the hard disk
as part of the project.
• Patch data included in an already existing project can be
loaded into the current project ( → p. 128).
Editing the name of an insert effect
patch
This section explains how to edit the name of the currently
selected patch.
1.
Press the [EFFECT] key in the display section, and
then press the [EDIT] key.
The currently selected patch can now be edited.
2
FLANGER FLANGER
DEPTH
DEPTH
20 20
TOTAL TOTAL
PAT LVL
PAT LVL
Patch level
1
Store Store
MRS-Drv
MRS-Drv
Patch number