Zoom MRS-1266 - Manual (Page 40)

Reference [Recorder]
ZOOM MRS-1266
40
Moving to a desired point in the
song (Locate function)
You can specify a location within the song in time units
(minutes/seconds/milliseconds) or in measure units (measure/
beat/tick) units, and move to that location.
1.
With the recorder stopped, use the cursor left/right
keys from the main screen to move the flashing
part to the unit you want to change.
For example, to change the minutes, cause the segment
marked "M" to flash.
2.
Turn the dial to specify the numeric value.
On the time indication, minutes, seconds, or milliseconds
can be specified. On the measure indication, measures,
beats, or ticks can be specified. When you change the
displayed value, the unit immediately moves to the new
location. Pressing the PLAY [ R ] key starts playback from
that point.
Re-recording only a specified
region (Punch-in/out function)
Punch-in/out is a function that lets you re-record just a
specified region of a previously recorded track. The action of
switching a currently-playing track to record mode is called
"punch-in", and the action of switching back from recording
to playback is called "punch-out".
The MRS-1266 provides two ways to do this. You can use
the panel keys or a foot switch (sold separately) to punch-in/
out manually ("manual punch-in/out"), or cause punch-in/
out to occur automatically at previously specified points
("auto punch-in/out").
Using manual punch-in/out
This section describes how to perform manual punch-in/out
to re-record a region of a previously recorded track, using
the panel keys or a foot switch (sold separately).
H INT
If you want to use a foot switch (ZOOM FS01/FS02) for
punch-in/out, connect the foot switch to the [FOOT SW] jack
on the front panel.
N OTE
With the default settings of the MRS-1266, a foot switch
connected to the [FOOT SW] jack is set to control recorder
playback/stop. If you want to use the foot switch to punch-
in/out, you must first change the foot switch setting ( → p.
153).
1.
Repeatedly press the status key of the track on
which you want to perform punch-in/out, until the
key is lit in red.
2.
Raise the fader of this track to a suitable position.
3.
While playing the instrument connected to the
INPUT jack, use the [INPUT] control and [REC
LEVEL] control to adjust the recording level.
During playback, use the faders of the mixer section to
adjust the mix balance of your instrument and the playback
of the tracks.
307- 307- 2. 2.
0 10 12 660
Hours
Minutes Millisecond
Seconds Measure
Beat
307- 307- 2. 2.
0 12 660