Zebra Technologies Cameo Portable Encoding Printer - Manual (Page 8)

8
UMAN-PEP
Conditioning Battery Packs
IMPORTANT
Cameo batteries must be cycled several times
before maximum capacity is realized.
A battery is ”cycled” by fully charging it, then
fully discharging it through normal use.
Chargers
Listed below are the specifications for the Cameo PEP
chargers:
UCN72-4: (p/n series AC15482-tab)
Designed to charge up to four batteries simulta-
neously. Battery packs may be charged separately
or while plugged into the printer. Typical charge
time is 90 minutes. Switch selectable 110/220
V.A.C. input voltage. Supplied with line cords
compatible with most international standards.
Do not attempt to charge batteries with the
UCN72-4 Charger while printing. Attempting to
print while charging batteries can result in unreli-
able charging.
Part numbers will vary depending on specific coun-
try of use. Consult factory for complete part num-
bers.
UC72N: (p/n series AT15244-tab)
A wall mounted single charger . Universal 110 to
230, 50-60 Hz. VAC input. Multiple plug configura-
tions comply with most international standards.
Do not attempt to charge batteries with the
UC72N Charger while printing. Attempting to print
while charging batteries can result in unreliable
charging.
Part numbers will vary depending on specific coun-
try of use. Consult factory for complete part num-
bers.
.