Zanussi ZCOF 637 X - Manual (Page 62)

60
WATER TANK
•
If left unused for long periods it is advisable to
replace the water in the tank with fresh water and to
empty the boiler by pressing the coffee button
(ref.4) repeatedly.
•
Clean the water tank (ref.27) periodically to remove
any lime-scale.
•
The water tank is dish-washer safe.
•
If Brita decalcifying filters are used it is advisable
to replace the filter every 2000 espresso coffees or
at least every two months.
BOILER CLEANING FREQUENCY
•
Like any other appliance that uses water, it is
perfectly normal for lime-scale to form inside the
boiler of the coffee machine.
- It is advisable to clean the boiler every six months
as follows:
- Fill the tank with 1.5l water and add half a glass of
vinegar or citric acid.
- Press the coffee button repeatedly so that the
water/vinegar solution comes through a little at a
time until the tank is empty.
- Repeat the operation until clean water comes
through (with no trace of lime-scale).
- Fill the tank with cold water and again press the
coffee button repeatedly to rinse the boiler.
- The machine is now ready for use.
FAULTS
If the machine does not work, check that the problem is
not due to:
1. No power supply
2. An empty water tank
If the power supply cable is damaged or for any other
maintenance operations, contact an
Authorised
Zanussi Technical Assistance Centre.
TECHNICAL
ASSISTANCE AND
SPARE PARTS
If the problem persists after carrying out the
check-ups indicated in the previous chapter,
contact your nearest authorised Technical
Assistance centre. Always describe the fault
and give the model (
Mod.), product number
(
Prod. no.) and serial number (Ser. No.) of the
appliance which are indicated on the
identification plate of the coffee machine.
The plate is located on the external right-hand
side of the machine and is clearly visible when
the machine is opened.
SERVICE AND SPARE PARTS
(UK)
In the event of your appliance requiring
service, or if you wish to purchase spare parts,
please contact your local
Zanussi Service
Force Centre by telephoning:
0870 5 929929
Your telephone call will be automatically
routed to the Service Force Centre covering
your post code area. The addresses are listed
on the following pages.
Before calling out an engineer, please ensure
you have read the details under the heading
“FAULTS”.
When you contact the Service Force Centre
you will need to give the following details:
1. Your name, address and post code
2. Your telephone number
3. Clear and concise details of the fault
4. The model and serial number of the
appliance.
5. The purchase date