Zebra Technologies 2742 - Manual (Page 11)

Before You Load
Media in the
Printer
You must remove the outside length of media
(that is, one, full revolution of labels and any
liner). When you remove this part of the media,
you remove the oils, dust, and adhesives that
contaminate it. Tape or adhesive holds the
loose end and the outside length of media
becomes contaminated when handled or
stored.
You must avoid dragging adhesive or dirty
media between the print head and platen. Such
an occurrence damages the print head and is
not covered under your warranty. Using clean
media prevents damage and reduces wear on
the print head and platen.
980344-001 Rev.A
7
Installation and Operation
Labels
Remove all labels
that are held by
adhesives or tape
Tag Stock
Detach both ends of
the bottom tag
MOVIE