Zebra Technologies 2742 - Manual (Page 27)

Printer
Configuration
Settings
The printer has flash (non-volatile) memory to
store printer configuration settings. The settings
are stored in flash memory and are set by
programing, printer drivers or the AutoSense
routine. The settings are shown on the Dump
mode printout or can be reported back to the
host via the serial port.
The following are the basic settings stored in the
printer:
Print Mode - Direct (OD) or Thermal Transfer (O)
Speed (S)
Density (D) or heat applied
Form (label) length and gap in dots (Q)
Form (label) width in dots (q)
Serial Port (Y)
Margin (R)
Buffer Mode (r)
Options: D
Print Mode is Direct Thermal (OD)
980344-001 Rev.A
23
Dump Mode
Printout
(See the U command in
the Programmer’s manual
for details)