Yamaha RX-V1070 - Manual (Page 15)

Set to the “
∞
” position.
Select the desired input source with the input selector
switches. (For video sources, turn the TV/monitor ON.)
* The indicator corresponding to the
selected input source will illuminate.
Select the front speakers to be used.
* If you use two front speaker systems, press both the A
and B switches.
Play the source. (For detailed information on the tuning
operation, refer to the page 17.)
Adjust to the desired output level.
15
OPERATIONS
If desired, adjust the BASS, TREBLE, BALANCE
controls, etc. (refer to page 16) and use the digital
sound field processor. (Refer to page 19.)
To play a source
1
2
3
4
5
6
7
Select the source to be recorded.
* “AUX” is not present
on RX-V870.
Play the source.
Confirm the source by selecting it with the input
selector switch and turning up the VOLUME control.
Set the tape deck or VCR to the recording mode.
If your tape deck has three head monitoring capability,
you can monitor the signal just recorded by selecting
the tape deck in the recording mode with the input
selector switch.
* Also, refer to the manual of the tape deck being used.
To record a source to tape (or dub from a
tape to another)
1 1
2 2
3
3
4 4
5 5
Notes
• If you want to enjoy another source while recording, select it
with the input selector switch.
• Adjusting the VOLUME, BASS, TREBLE, BALANCE
controls, BASS EXTENSION and TONE BYPASS switch
and operating the digital sound field processor during
recording have no effect on the material being recorded.
Illustrations: RX-V1070
Parts in shaded areas ( )
are not present on RX-V870.
PHONES jack
TONE BYPASS
BASS EXTENSION
Tuner controls
7
2
4
3, 3 3 , 5 5
1, 6, 3 3
1 1
7
POWER
SPEAKERS