Zenith L20V54S - Manual (Page 54)

L20V54S Aux Input Configuration
DIRECT ACCESS
Tuning
OLD_OCV
=0
131 91 Video1(Rear) CV ONLY
DTV/PC Auto
39 REAR_AUX_EN 0x02 1
Rear Video
(Aux)
0(VIDEO) 1
Rear Video
(Aux)
133 93 DVI/HDMI1 35 COMPPORT EN 0x08 3
Front
Computer
0(VIDEO) 3
Front
Computer
OLD_OCV
=1
Source Input Source Mode Number Value Value Labeling Labeling Labeling
L20V54S
ENABLE
Installer Menu
MPI DATA
STATUS TYPE
0x41 SOURCES
ENABLED (R/W)
DATA STATUS
TYPE 0xD2
CURRENT AV
SOURCE (R)
DATA
STATUS
TYPE 0X0D
AUX
SOURCE
(R)
MPI DATA
STATUS
AUX
SOURCE
ASSIGNMENT
Troubleshooting
Symptoms Possible Cause(s) Possible Solution(s) See Page(s)
TV not functioning
properly.
Virtual and Physical
channels appear in
channel scan w/Channel
Up/Down.
Can not direct enter
channel number Channel not included in
channel scan in TV controller. After 2-5-5 + MENU, only channels included in TV controller will appear.
If channel is available, redo channel scan. If it is not available it will not
appear on the TV screen.
2-5-5 + MENU not performed. After Auto Program and Channel List, etc. press 2-5-5 + MENU to transfer
channels and TV setup to internal TV controller. Afterward, only Physical or
only Virtual channels will appear in digital channel scan, analog channel
scan will be normal.
*Note: Be sure to set item 028 Ch Overide to 000.
Software lockup. Remove power cord for 5 minutes. 41
41
41
Software Problems
Software Corrupted. 2-5-5 + MENU performed
more than once. Start all over with item 117, set to 001, press Enter then redo Auto Program,
Channel List,Clock, etc. *Note: 2-5-4 + MENU can be done more than once. 41
Some quick and easy tips to resolving problems.
P A G E 5 4
L20V54S Aux Input Configuration / Troubleshooting