Zenith L20V54S - Manual (Page 60)

P A G E 6 0
Installer Quick Setup Guide
Quick Setup Guide
for Integrated Master TVs
See table of contents for more information.
Setup Instructions for Making a Master TV
1. Connect TV to signal source, connect power cord and turn TV power on.
2. Enter the TV installer menu.
*Note: If this is not a new setup, set Installer item 117 to 001 and press Enter to
reset TV to default condition.
• Set Tuning Band.
Set Installer menu item 003 BAND/AFC to CATV: 001, Broadcast: 000 etc.
• If necessary, set Installer menu item 028 CH OVERIDE to 001.
In addition, set any other installer items as required of your system.
Exit Installer menu.
3. Access the Master TV menus and set the clonable options on the menus to the
desired configurations. Refer to the Clonable Menu Features Chart for the TV.
(Picture, Sound, Time etc.)
4. Do a Channel Search; run Auto Program. (aka EZ Scan.)
5. Enter the Channel Edit menu and delete channels per your requirements.
6. Enter the Channel Label menu and assign ICONs to the channels.
*Note: You can add Channel ICONStypically network logos like ABC, NBC, PBS etc. in
this step. Or, in Step 8, add Channel ICONSor custom text labels for channels which no
Icons are available for.
7. Transfer the TV setup. After all menu options and features are set to your
requirements, enter the installer menu. Press ‘2’, ‘5’, ‘5’, ‘MENU’ to start the transfer
of the TV’s setup to the PTC.
After the transfer is complete, the system will exit the Installer menu.
8. Set any Channel Labels as needed.
a. Enter Installer menu.
b. Press ‘2’, ‘5’, ‘4’, ‘MENU’ to enter the menu. In this menu edit the assigned
channel Icons, assign custom text labels for channels and assign labels for active
Aux sources. Press ‘Menu’ to exit.
9. Enter the Installer menu. Set item 028 Ch Overide to 000 and exit menu.
L20V54S PTC INSTALLER MENU
117 FACT DEFAULT 00X
003 BAND/AFC 00X
028 CH.OVERIDE 001
028 CH.OVERIDE 000
000 INSTALLER SEQ 000
UPN 000-000-000-000 FPGA 09F1
PTC V1.00.000 CPU V1.01.00
WXYZ
DIGITAL 19-3
MONO SAP STEREO WXYZ
ANALOG 2
MONO
AC IN HDMI
IN RS-232C
SPEAKER SWITCH
PILLOW
SPEAKER NORMAL
SPEAKER FUTURE
USE UPDATE VIDEO
AUDIO IN VIDEO IN
RS-232C
SELECT
CONTROL NORMAL
(DTV)
Antenna
Wall Jack
AC Power
Cord
RF Coaxial Wire
(75ohm)
Sound
Move Select OK Menu Back
Mode Standard G
Balance
Auto Volume On
English Multi-Track
Internal Speaker On
11:20 PM
Sep.11, 2006
Channel
Move Select OK Menu Back
Antenna
Auto Program G
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
--.-- ----
Channel
Searching ...
ANALOG34 added
30
Menu Back
Antenna
Auto Program
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
--.-- ----
Picture
Move Select OK Menu Back
11:20 PM
Sep.11, 2006
Mode
Color Temperature
Standard G
Contrast 100
Brightness 79
Sharpness 65
Color 70
Tint 0
Screen Format
Noise Reduction
Film Mode