Zenith L20V54S - Manual (Page 9)

Antenna Hookup
P A G E 9
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking
through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
1
2
3
Locate the Antenna/Cable jack on the back
of the LCD TV/Monitor.
Connect the antenna wire (Flat or Round)
that runs from the wall to this jack,
according to one of the diagrams shown to
the right.
After all connections are complete, plug in
the TV. The LCD TV/Monitor is designed to
operate on AC power.
Connect an off-air antenna to the LCD TV/Monitor.
If the antenna is a 75 ohm RF cable, then no
adapters are required.
A 300 to 75 ohm adapter is not included with
the Zenith LCD TV/Monitor.
300 TO 75 OHM
ADAPTER
SPEAKER SWITCH
PILLOW
SPEAKER NORMAL
SPEAKER FUTURE
USE RS-232C
SELECT
CONTROL NORMAL
(DTV)
SPEAKER SWITCH
PILLOW
SPEAKER NORMAL
SPEAKER FUTURE
USE RS-232C
SELECT
CONTROL NORMAL
(DTV)
RF Coaxial Wire
(75 ohm)
300/75 ohm
Adapter
Connections Panel
Connections Panel
Flat Wire
(300 ohm)