Yamaha RX-V561 - Manual (Page 63)

59
En
Remote control features
English
AD
V
ANCED
OPERA
T
ION
You can control other components by setting the
appropriate remote control codes. For a complete list of
available remote control codes, refer to “List of remote
control codes” at the end of this manual.
Remote control code default settings
You may not be able to operate your Yamaha component even if a
Yamaha remote control code is preset as listed above. In this case,
try setting another Yamaha remote control code.
1
While pressing and holding one of the input
selector buttons (
C) on the remote control to
select the input area you want to set up,
press
AV POWER for more than 3 seconds.
2
Press the numeric buttons (0 to 9) (W) to
enter the four-digit remote control code for
the component to be used.
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you do not press any buttons within 30 seconds in step 2, the
setup process is canceled. If this happens, repeat the setup
procedure.
Setting remote control codes
Input
source
Component
category
Manufacturer
Default
code
CD CD YAMAHA 5013
MD/CD-R CD-R YAMAHA 5001
DVD DVD YAMAHA 2000
DTV/CBL – – –
TUNER TUNER YAMAHA 5007
V-AUX – – –
USB USB YAMAHA 5012
DVR DVR YAMAHA 2011
– – –
Note
Notes
DVD
V-AUX USB
DTV/CBL DVR
CD MD/CD-R TUNER
POWER
AV
While holding down Press for 3 seconds