Zephyr ZVE-E42S - Manual (Page 13)

11
F
eatures
&
Controls
-
Charcoal
Filters
Change
Indicator
Filter Change Reminder (Charcoal, if fitted):
When your hood is installed as a 'Recirculating' (Ductless) unit, it is fitted with a set of Charcoal Filters to
purify exhaust and fumes from cooking, then re-circulate the air within the home.These Charcoal Filters are required
to be replaced after every 120 hours of use. The Filter Change Reminder
function in the microprocessor needs to
be switched on. The microprocessor in the controls when set, will elapse and count usage time and indicate by a
flashing when charcoal filter replacement is needed.
Setting the Filter Change Reminder:
When Off, hold for approx. 5 seconds.
The display will change from
(exhaust mode) to , (purifying mode/
carbon filters used) this indicates that the
elapse timer function is switched on and
Charcoal Filters are used.
Filter Replace Indicator:
When the display starts flashing, the
Charcoal Filters require replacement.
Re-setting Function:
Once filters are replaced, with hood off,
press and hold , the display will appear;
hold for approximately 5 seconds until
on display disappears . The Filter
Change Reminder is now re-set and a new
120 hours elapse cycle is initiated.
hold 5 secs.
hold 5 secs.
display from <--> to <C>
display from <C> to < >
display <C> flashes
Set Mode
Change Filters
To Reset