Zebra 105SL - Manual (Page 107)

99 Configuration
Control Panel Parameters
6/30/06 105SL User Guide 11342L-001 Rev. A
Specify IP Address
2
This parameter allows you to select the IP address if PERMANENT was
chosen in IP PROTOCOL. (If a dynamic option was chosen, the user
cannot select the address.)
To change the value shown:
1. Press MINUS (–) to move the cursor.
2. Press PLUS () to increase the value of the digit.
Specify Subnet Mask
2
This parameter selects the part of the IP address that is considered to be part
of the local network. It can be reached without going through the default
gateway.
To change the value shown:
1. Press MINUS (–) to move the cursor.
2. Press PLUS () to increase the value of the digit.
Specify Default Gateway
2
This parameter allows you to select the IP address that the network traffic is
routed through if the destination address is not part of the local network.
To change the value shown:
1. Press MINUS (–) to move the cursor.
2. Press PLUS (+) to increase the value of the digit.
View MAC Address
1,3
Displays the MAC address of the wireless card. This parameter cannot be
changed through the control panel.
View ESSID
1,3
This parameter cannot be changed through the control panel. Use the ^WS
ZPL command to change the value. For more information, see the Wireless
Print Server User Guide.
Select Authentication Type
1,3
If encryption is on, specify whether to use open or shared authentication.
Default: OPEN
Selections: OPEN, SHARED
To change the value shown:
1. Press PLUS (+) or MINUS (–) to toggle between the options.
Table 10 • Print Server Parameters (Page 2 of 4)
Parameter Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
IP ADDRESS
000.000.000.000
SUBNET MASK
000.000.000.000
DEFAULT GATEWAY
000.000.000.000
MAC ADDRESS
000000000000
ESSID
125
AUTH. TYPE
OPEN