Zebra Technologies XiIII - Manual (Page 69)

Zebra XiIII-Series User’s Guide 63
Press Display Shows Action/Explanation
LANGUAGE
Selecting the Display Language Press the RIGHT or LEFT BLACK
OVAL key to display other choices.
Default: English
Selections: English, Spanish, French, German, Italian,
Norwegian, Portuguese, Swedish, Danish,
Spanish 2, Dutch, Finnish, Custom
This parameter allows you to change the language used on the
front panel display.
You have now completed the entire configuration and calibration sequence. You may either
press the NEXT/SAVE key or the SETUP/EXIT key.
DARKNESS
You are now back at the first parameter in the configuration
sequence.
NOTE: If you pressed the NEXT/SAVE key but are through
programming the printer configuration, you may press
the SETUP/EXIT key and continue with the “SAVE
SETTINGS” function.
SAVE SETTINGS
Save Settings Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: Permanent
Selections: Permanent, temporary, cancel, load defaults,
load last save.
This display appears when you attempt to exit the configuration
mode.
• Permanent: Permanently saves the changes, even when printer
power is turned off.
• Temporary: Saves the changes until changed again or until
power is turned off.
• Cancel: Cancels all changes since you entered the
configuration mode except for darkness and tear-off position (if
they were changed).
• Load defaults: Loads factory defaults.
NOTE: Loading factory defaults will require calibration and
resetting the head resistor value.
• Load last save: Loads the values from the last permanent save.
PRINTER READY
Press the NEXT/SAVE key to activate the displayed choice.
You have exited the configuration and calibration sequence and
are now ready for normal printer operation