Zebra Technologies XiIII - Manual (Page 73)

4. Rotate the platen roller and clean thoroughly with solvent and an
applicator.
5. Brush/vacuum any accumulated paper lint and dust away from the
rollers.
6. Reload ribbon and/or media, and close and the printhead.
Cleaning the Sensors
The media, ribbon, and label available sensors should be cleaned on a
regular basis to ensure proper operation of the printer. To locate these
sensors, refer to Figure 27,
Figure 6 on page 11, and Figure 7 on page 12.
Brush/vacuum any accumulated paper lint and dust off of these sensors.
Zebra XiIII-Series User’s Guide 67
Ribbon
sensor
Black
mark
sensor
Tear-off/peel-off
bar
Platen
roller
Label
available
sensors
Printhead
Printhead
lever
Figure 27