Yamaha mLAN8E - Manual (Page 16)

16
English
Settings on the device in which the mLAN8E is installed
MIDI Other
An CS6x/CS6R/S80 in which the mLAN8E is installed will have the following additional functions.
■
In (MIDI Input)
Select whether to use the MIDI connector or the mLAN connector as the input route for MIDI
messages. If you select “mLAN,” the HOST SELECT switch will have no effect, and MIDI mes-
sages from devices connected to the TO HOST connector or MIDI IN connector will not be
input.
❑ Setting: MIDI, mLAN
Regardless of this setting, MIDI OUT messages will be output both from the
MIDI OUT connector and the mLAN connector.
If you select mLAN, MIDI OUT messages will not be output from TO HOST.
If you select mLAN, the ThruPort setting will have no effect.
■
Sync (when the above MIDI Input = mLAN)
When playing in synchronization with an external device, specify whether the CS6x/CS6R/S80
will operate using its own internal clock or the MIDI Clock received via the mLAN connector. If
you select “Int (internal),” the CS6x/CS6R/S80 will operate using its own internal clock. Select
this when using the CS6x/CS6R/S80 by itself or as the master of a synchronized performance
using MIDI Clock. If you select “MIDI,” the CS6x/CS6R/S80 will operate according to the
MIDI Clock received via the mLAN connector. Select this when using the CS6x/CS6R/S80 as a
slave of a synchronized performance using MIDI Clock.
❑ Setting: MIDI, int (internal)
■
SeqCtrl (Sequence Control) (when the above MIDI Input = mLAN)
Specify whether or not you wish to transmit and receive the mLAN MIDI messages Start, Stop,
and Continue. This is also a switch for outputting MIDI Clock from mLAN MIDI output.
❑ Setting: off (don’t transmit or receive), on (transmit and receive)
MIDI Other) In ThruPort Sync SeqCtrl
Sys mLAN 1 int on
NOTE
NOTE
NOTE