Cleaning the oven, Cleaning materials, External cleaning – Zanussi ZBM 879 User Manual

Page 20: Oven cavity, Oven shelves and shelf supports, Replacing the oven light

Advertising
background image

20

FO 0287

F

Before cleaning always allow the cooling fan to

cool the oven down before switching off at the

electricity supply.

The oven should be kept clean at all times. A

build-up of fats or other foodstuffs could result in

a fire, especially in the grill pan.

Cleaning materials

Before using any cleaning materials on your oven, check

that they are suitable and that their use is recommended

by the manufacturer.

Cleaners that contain bleach should NOT be used as

they may dull the surface finishes. Harsh abrasives

should also be avoided.

External cleaning

Regularly wipe over the control panel, oven door and door

seal using a soft cloth well wrung out in warm water to

which a little liquid detergent has been added.

To prevent damaging or weakening the door glass

panels avoid the use of the following:

• Household detergent and bleaches
• Impregnated pads unsuitable for non-stick

saucepans

• Brillo/Ajax pads or steel wool pads
• Chemical oven pads or aerosols
• Rust removers
• Bath/Sink stain removers

Clean the outer and inner door glass using warm soapy

water. Should the inner door glass become heavily soiled

it is recommended that a cleaning product such as Hob

Brite is used. Do not use paint scrapers to remove

soilage.

DO NOT clean the oven door while the glass

panels are warm. If this precaution is not observed

the glass panel may shatter.

If the door glass panel becomes chipped or has

deep scratches, the glass will be weakened and

must be replaced to prevent the possibility of the

panel shattering. Contact your local Service Force

Centre who will be pleased to advise further.

Oven Cavity

The enamelled base of the oven cavity is best cleaned

whilst the oven is still warm.

Wipe the oven over with a soft cloth soaked in warm

soapy water after each use. From time to time it will be

necessary to do a more thorough cleaning, using a

proprietary oven cleaner.

DO NOT attempt to clean catalytic liners

Cleaning the Oven

Oven Shelves and Shelf

Supports

To clean the oven shelves and the shelf supports, soak

in warm soapy water and remove stubborn marks with a

well wetted soap impregnated pad. Rinse well and dry

with a soft cloth.

The shelf supports can be removed for easy cleaning

(see diagram). Please, ensure the retaining nuts are

secure when refitting the shelf support.

When cleaning the shelf supports, take care not

to remove the lubricating grease behind the

telescopic runners. This is meant to ensure their

good operation.

Replacing the Oven Light

If the oven bulb needs replacing, it must comply with the

following specifications:
- Electric power: 15W,

- Electric rate: 230-240 V (50 Hz),

- Resistant to temperatures of 300°C,

- Connection type: E14.

These bulbs are available from your local Zanussi Force

Service Centre.

To replace the faulty bulb:

1. Ensure the oven is isolated from the electrical supply.

2. Turn the glass cover anticlockwise.

3. Remove the faulty bulb and replace with the new one.

4. Refit the glass cover.

5. Restore the electrical supply.

Advertising