Yashica 635 - Manual (Page 5)

FILM LOADING
1. Open the Back Cover by turning the Back
Cover Release Ring around the Tripod
Socket in the direction of "0" (Open) .
2. After opening out the Back Cover, remove
the Take-up Spool from the lower Film
Chamber by pulling out the lower Spool
Stud Knob.
3. While pulling out the upper Spool Stud
Knob, set the Take-up Spool in the upper
Film Chamber.
CAUTION: Before loading the film, make
sure the 35 mm Film Rewind Release
Button (27} is reset all the way into its
original position.
4. Pull out the lower Spool Stud Knob
and place a new roll of film (standard
120 roll film) into position in the lower
Film Chamber.
4www.butkus.org
5. Pull the film leader gently and insert
it into the slot on the Take-up Spool in
the upper Film Chamber. Make sure
the film leader is inserted into the
wider one of the two slots and its edge
is set flush against the spool flange.
6. Turn the Film Advance Knob until
the arrow "start" mark on the film
leader aligns with the triangular mark
on the edge of the picture frame. Then
close the Back Cover.