Yamaha CLP-220 - Manual (Page 34)

CLP-220 Keyboard Stand Assembly 34
ENGLISH
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to
install all parts in the correct direction. Please
assemble in accordance with the sequence given
below.
• Assembly should be carried out by at least two per-
sons.
• Be sure to use the included screws only, and insert
screws of the correct size in the correct hole loca-
tions. Do not use any other screws. Use of incorrect
screws can cause damage or malfunction of the
product.
• Be sure to tighten up all screws upon completing
assembly of each unit.
• To disassemble, reverse the assembly sequence
given below.
Remove all parts from the package and make sure you
have all of the items.
1.
Attach (finger-tighten) C to D and E.
1-1 Untie and straighten out the bundled pedal
cord. Don’t discard the vinyl tie. You will
need it later in step 6.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening the
long screws 1 (6
× 20mm).
2.
Attach B.
Depending on the model of Clavinova you purchased,
the surface color of one side of B may be different from
the other side. In this case, position B so that the side
of the surface color similar to D and E faces the player.
2-1 Place the lower side of B on each foot of D
and E, then attach the upper side to D and E.
2-2 Attach the top of B to D and E by finger-
tightening the thin screws 3 (4 × 12mm).
2-3 While pushing the lower part of D and E
from outside, secure the bottom ends of B
using two tapping screws 4 (4
× 20mm).
2-4 Insert the other two tapping screws 4 (4 ×
20mm) into the other two screw holes to secure
B.
Have a Phillips-head (+) screwdriver ready
Assembly Parts
6 × 20 mm long screws Ч4 1
4 Ч 12 mm thin screws ×2 3
Cord holders × 2
Side panel protection
(cardboard) pads
Ч 2
6 Ч 16 mm short screws Ч4 2
4 Ч 20 mm tapping screws Ч4 4
4 Ч 10 mm thin screws ×2 5 Headphone hanger
Headphone hanger set
Bundled pedal
cord inside
AC power cord
D E
A
B
C
L
1-2
1-1
1-3
D
E
C
L
Place the bottom
ends of the rear
panel on each foot.
2-1
D
B
E 2-2
2-4
2-3
2-3
32