Tuner (fm) xm satellite radio – Yamaha DVX-700 User Manual
Page 72
TROUBLESHOOTING
68
En
Tuner (FM)
XM Satellite Radio
If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel
display. In this case, read the causes and follow the corresponding remedies.
The picture is not displayed on the TV
screen.
The TV cables may be connected
improperly.
Make sure all cables are connected
properly.
If the COMPONENT VIDEO
OUTPUT and HDMI connections are
used simultaneously, the
COMPONENT VIDEO OUTPUT
jacks may output progressive video
signal regardless of the Component Out
setting.
Disconnect the HDMI component, or
connect a TV that supports progressive
video to the COMPONENT VIDEO
OUTPUT jacks.
The picture is not displayed on the TV
screen correctly.
The Video Output settings may be
incorrect.
Check the Video Output settings and
correct as necessary.
The Component Out setting is set to
Progressive, but the TV connected to
the COMPONENT VIDEO OUTPUT
may not support progressive scanning.
Change the Component Out setting to
Interlace.
The TV connected to the HDMI
OUTPUT terminal may not support the
selected resolution.
Change the HDMI Resolution setting
to a resolution supported by the HDMI
TV.
The message “HDMI ERROR” is
displayed or the picture is not
displayed on the HDMI TV screen.
The wrong HDMI resolution may be
selected or an HDMI error may have
occurred.
Check the HDMI Resolution setting
and correct as necessary.
Reset the HDMI settings.
Problem
Cause
Remedy
See
page
FM stereo reception is noisy.
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away, or
if the antenna quality is poor.
Check the antenna connections.
Try using a high-quality directional FM
antenna.
--
Use the manual tuning method.
There is distortion, and clear reception
cannot be obtained, even with a good
FM antenna.
There is multi-path interference.
Adjust the antenna position to
eliminate multi-path interference.
--
The desired station cannot be tuned
into with the automatic tuning method.
The signal is too weak.
Use a high-quality directional FM
antenna.
--
Use the manual tuning method.
Status message
Cause
Remedy
See
page
CHECK XM TUNER
The XM Mini-Tuner is not installed in
the XM Mini-Tuner Home Dock or the
XM Mini-Tuner Home Dock is not
connected to this unit.
Confirm the XM Mini-Tuner is fully
seated in the dock and check that the
XM Mini-Tuner Home Dock cable is
connected to this unit.
CHECK ANTENNA
The XM antenna is not connected to
the XM Mini-Tuner Home Dock or the
XM antenna cable has become
damaged.
Check that the XM antenna is securely
connected to the XM Mini-Tuner
Home Dock and check the antenna
cable for damage. Replace the XM
antenna if the cable is damaged.
Problem
Cause
Remedy
See
page