Bluetooth, Disc – Yamaha DVX-700 User Manual
Page 75
TROUBLESHOOTING
71
En
ADD
ITIONAL INFORMATION
8
Eng
lish
Bluetooth
Note
In case of a transmission error without a status message appearing in the front panel, check your Bluetooth
component.
Disc
Status message
Cause
Remedy
See
page
Searching...
The Yamaha Bluetooth wireless audio
receiver (such as YBA-10, sold
separately) and the Bluetooth
component are in the process of the
pairing.
--
--
The Yamaha Bluetooth wireless audio
receiver and the Bluetooth component
are in the process of establishing the
connection.
--
--
Completed
The pairing is completed.
--
--
Canceled
The pairing is canceled.
--
--
Not found
The system cannot find the Bluetooth
component while performing the
pairing or trying to connect to the
Bluetooth component.
--
--
BT connected
The connection between the Yamaha
Bluetooth wireless audio receiver and
the Bluetooth component is
established.
--
--
Disconnected
The Bluetooth component is
disconnected from the Yamaha
Bluetooth wireless audio receiver.
--
--
Not Available
The pairing is performed when the
Yamaha Bluetooth wireless audio
receiver is connected to the Bluetooth
component.
Perform the pairing when the Yamaha
Bluetooth wireless audio receiver is not
connected to the Bluetooth component.
Problem
Cause
Remedy
See
page
Some functions do not work.
Not all discs support all of the disc
playback functions of this unit.
Try another disc.
Playback does not start, the sound or
picture is distorted or playback is
stopped halfway.
The disc is not properly set.
Place the disc, label-side up.
The disc is dirty.
Check the disc and clean as necessary.
The loaded disc in not supported.
Use only supported disc formats.
The Disc that is not compliant with the
CD Audio specification (e.g. copy
control CD, the non-DVD side of the
DualDisc, etc.) may not play.
Condensation on the pickup lens. When
this system is moved from a cold
environment to a warm one,
condensation may form on the pickup
lens.
Wait for one to two hours for the
condensation to evaporate, then try
again.
--
After loading a DVD-Video, the same
picture is usually displayed and you
cannot move to the main contents or
the main menu.
The Resume/Last memory function is
effective.
Press s twice to set the Resume
function to off.
Reset the DVD setting to the initial
factory settings (DVD INIT) to clear
the resume point.