Yamaha CVP-409 - Manual (Page 94)

Using, Creating and Editing
V
oices
Editing the Volume and Tonal Balance (MIXING CONSOLE)
CVP-409/407 Owner’s Manual 94
10
If you have selected one of the DSP 2–5 effect blocks in step 5:
You can edit its standard parameters as well as its variation parameter.
To select the standard type of parameters, press the [B] button. To select its
variation parameter, press the [E] button.
11
Select one of the parameters you want to edit by using the [4π π π π† † † † ]/
[5π π π π† † † † ] buttons.
Available parameters differ depending on the selected Effect type.
12
Adjust the value for the selected parameter by using the [6π π π π† † † † ]/
[7π π π π† † † † ] buttons. If you have selected the REVERB, CHORUS or DSP1
effect block in step 5:
Adjust the Effect Return Level by pressing [8π†] button.
13
Press the [I] (SAVE) button to call up the display for saving your origi-
nal effect.
14
Use the [3π π π π† † † † ]–[6π π π π† † † † ] buttons to select the destination for saving
the effect.
The maximum number for effects that can be saved differs depending on the
effect block.
15
Press the [I] (SAVE) button to save the effect (page 69).
When recalling the saved effect, use the same procedure as in step 8.
Re-selecting the Effect block,
category and type
Use the [1π†]–[3π†] but-
tons. The re-selected effect con-
figuration is displayed at the
upper left side box in the display.
Effect Return Level:
Determines the level or amount
of effect applied.
This is set for all parts or chan-
nels.
10
13
11 12
14
15