Yamaha DSP-AZ2 - Manual (Page 25)

23
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC
OPERAIONT
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
Selecting the OSD Mode
1 Turn on the video monitor connected to this
unit.
2 Press ON SCREEN on the remote control
repeatedly to change the display mode.
The OSD mode changes in the following order: full
display, short display, and display off.
If the video monitor is connected to the
COMPONENT VIDEO MONITOR OUT jacks of this
unit, the OSD can be shown only when operating the
SET MENU. However, the OSD cannot be
superimposed over the image.
Notes
• Playing back video software that has an anti-copy signal or
video signals with a lot of noise may produce unstable images.
• The OSD signal output to the COMPONENT VIDEO
MONITOR OUT jacks is created from the composite or S-
video signal. Therefore, the quality of the OSD signal may vary
depending on the signal input through the VIDEO or S VIDEO
jacks.
P01 CONCERT HALL 1
≥ D S P L E V E L … … … … 0 d B
I N I T . D L Y … … … … 3 0 m s
R O O M
S I Z E … … … … 1 . O
L I V E N E S S … … … … … … … 5
E u r o p e H a l l A
P 0 1 C O N C E R T H A L L 1
E u r o p e H a l l A
PARAMETER
SET MENU
LEVEL ON SCREEN
TEST SLEEP
ON-SCREEN DISPLAY (OSD)
You can display the operation information for this unit on
a video monitor. If you display the SET MENU and DSP
program parameter settings on a monitor, it is much easier
to see the available options and parameters than it is by
reading this information on the front panel display.
y
• If a video source is being reproduced, the OSD is
superimposed over the image.
• The OSD signal is not output to the REC OUT jack, and will
not be recorded with any video signal.
• You can set the OSD to turn on (gray background) or off when
a video source is not being reproduced (or the source
component is turned off) by using “13 DISPLAY SET” on the
SET MENU (see page 65).
OSD Modes
You can change the amount of information the OSD
shows.
Full display
This mode always shows the DSP program parameter
settings on the video monitor.
Short display
This mode briefly shows the same contents as the front
panel display at the bottom of the screen and then
disappears.
Display off
This mode briefly shows the “DISPLAY OFF” message at
the bottom of the screen and then disappears. Afterwards,
no changes to operations appear on the monitor except
those of the ON SCREEN button.
Full display Short display
y
• When you choose the full display mode, INPUT, VOLUME
and some other types of operation information are displayed at
the bottom of the screen in the same format as that for the front
panel display.
• The SET MENU and test tone display appear regardless of the
OSD mode.
0104DSPAZ2_23-27_EN(GB) 02.8.22, 0:15 PM 23