Yamaha DSP-AZ2 - Manual (Page 50)

48
REMOTE CONTROL FEATURES
MACRO
MACRO
LEARN
TRANSMIT RE-NAME
STANDBY SYSTEM
CLEAR LEARN MACRO OFF ON MACRO
PHONO A B
CD
DVD VCR2/DVR VCR 1 D-TV/LD CBL/SAT
CD-R MD/TAPE TUNER V-AUX
POWER
LEARN
PHONO A B
CD
DVD VCR2/DVR VCR 1 D-TV/LD CBL/SAT
CD-R MD/TAPE TUNER V-AUX
Clearing a Macro Function
1 Press MACRO to clear a programmed macro
by using a ballpoint pen or similar object.
Note
• Complete each of the following steps in 30 seconds. Otherwise
the learning mode will be automatically canceled. In this case,
press MACRO again.
2 Press and hold CLEAR by using a ballpoint
pen or similar object, then press the button
for which you want to clear the macro for
about 3 seconds.
“C:OK” appears in the display window.
y
• You can clear other macros at this time by holding down
CLEAR again and pressing the other buttons for which those
macros have been programmed.
Note
• “C:NG” appears in the display window if the operation is
unsuccessful. In this case, try step 2 again.
3 Press MACRO again to exit from the clearing
mode.
Once you have cleared macro for a button, the button
reverts to the factory setting.
TRANSMIT RE-NAME
STANDBY SYSTEM
CLEAR LEARN MACRO OFF ON
MACRO
PHONO A B
CD
DVD VCR2/DVR VCR 1 D-TV/LD CBL/SAT
CD-R MD/TAPE TUNER V-AUX
POWER
Clearing a Learned Function
You can clear the function learned in a certain
programmable button in each area.
1 Press an input selector button, Å or ı to
select the source component you want to
clear the function.
The selected component name appears in the display
window.
2 Press LEARN by using a ballpoint pen or
similar object.
“LEARN” and the selected component name appear
alternately in the display window.
Note
• Complete each of the following steps in 30 seconds. Otherwise
the learning mode will be automatically canceled. In this case,
press LEARN again.
3 Press and hold CLEAR by using a ballpoint
pen or similar object, then press the button
for which you want to clear the function for
about 3 seconds.
“C:OK” appears in the display window.
y
• You can clear other learned functions at this time by holding
down CLEAR again and pressing the other buttons for which
those learned functions have been programmed.
Note
• “C:NG” appears in the display window if the operation is
unsuccessful. In this case, try step 3 again.
4 Press LEARN again to
exit.
Once you have cleared a learned function for a
button, the button reverts to the factory setting.
0108DSPAZ2_41-54_EN(GB) 02.8.22, 0:17 PM 48