Yamaha DSP-AZ2 - Manual (Page 65)

63
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC OPERA-
TION
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
SET MENU
9 PARAM. INI (parameter
initialization)
Use this feature to initialize the parameters for each DSP
program within a DSP program group. When you
initialize a DSP program group, all of the parameter
values within that group revert to their initial settings.
Press the corresponding numeric button for
the DSP program that you want to initialize.
The asterisk (*) next to the program number means
that the parameter values have been changed.
Notes
• You cannot initialize the individual DSP programs within a
group separately.
• When “14 MEMORY GUARD” is set to ON (see page 66),
you cannot initialize any program groups.
• Once you initialize a DSP program group, you cannot
automatically revert to the previous parameter settings.
9 PARAM. INI
* 5 6 7 8
9 * 1 0 1 1
P r e s s N o . K e y
1 2 3 * 4
10 LFE LEVEL
H E A D P H O N E … … … … 0 d B
≥ S P E A K E R … … … … … … 0 d B
10 LFE LEVEL
H E A D P H O N E … … … … 0 d B
≥ S P E A K E R … … … … - 1 1 d B
10 LFE LEVEL
This setting is effective only when this unit decodes
Dolby Digital or DTS signals.
Use this feature to adjust the output level of the LFE
(low-frequency effect) channel when playing back a
Dolby Digital or DTS signal. The LFE signal carries the
low-frequency special effect sound which is only added to
certain scenes.
Control range (dB): –20 to 0 for both SPEAKER and
HEADPHONE
Initial setting: 0 dB for both SPEAKER and
HEADPHONE
1 Press k / n to select the item to be adjusted.
2 Press –/+ to adjust the LFE level.
Note
• Adjust the LFE level according to the capacity of your
subwoofer or headphones.
8 INPUT MODE (initial input
mode)
Use this feature to designate the input mode for sources
connected to the DIGITAL INPUT jacks when you turn
on this unit (see page 30 for details about the input
mode).
Choices: AUTO, LAST
Initial setting: AUTO
AUTO
Select this to allow this unit to automatically detect the
type of input signal and select the appropriate input mode.
LAST
Select this to set this unit to automatically select the last
input mode used for that source.
Note
• Even if LAST is selected, the last setting for the EX/ES button
will not be recalled.
8 INPUT MODE
- / + : S e l e c t
/ : E x i t
A U T O L A S T
0109DSPAZ2_55-68_EN(GB) 02.8.22, 0:17 PM 63