Yamaha HTR-5960 - Manual (Page 40)

36
AUTO SETUP
y
If you are not satisfied with the results or want to manually
adjust each parameter, run “MANUAL SETUP” (see
page 83).
• If you change speakers, speaker positions, or the layout of
your listening environment, run “AUTO SETUP” again to
recalibrate your system.
• The distances displayed in the “DISTANCE” results may
be longer than the actual distance depending on the
characteristics of your subwoofer.
• In the “EQ” results, different values may be set for the
same band to provide finer adjustments.
8
Press ENTER to return to the top
“RESULT:EXIT” display.
9
Make sure the pointer is pointing at “SET”
and “CANCEL” and then press j / i to select
“SET” or “CANCEL”.
Choices: SET, CANCEL
• Select “SET” to confirm the “AUTO SETUP”
results.
• Select “CANCEL” to cancel the “AUTO SETUP”
results.
10
Press ENTER to confirm your selection.
The top “SET MENU” display appears in the OSD.
11
Press SET MENU to exit from “SET MENU”.
Notes
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH RESULT:EXIT
WARNING (3)
RESULT
. SP : 5/4/0.1
. DIST: 14.0/ 17.0ft
. LVL : -9.0/ +6.5dB
. >SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH RESULT:EXIT
WARNING (3)
RESULT
. SP : 5/4/0.1
. DIST: 14.0/ 17.0ft
. LVL : -9.0/ +6.5dB
. >SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH SET MENU
. ;AUTO SETUP
;MANUAL SETUP
. ;SIGNAL INFO
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
MENU
SET MENU
SRCH MODE