Zebra Technologies P310i - Manual (Page 11)

Card
Printer
Solutions
General information
Getting started
Operation
Cleaning
Specifications
Appendix A
Appendix B
Troubleshooting
Printing a card
Appendix C
4
PRINTER
INSTALLATION
The following will guide you through the
installation of your P310i Printer.
CAUTION: Limit AC power supplied to the P310i
to 110 ~ 230 volts, 60 ~ 50 Hertz, for an
associated 800 ~ 400 milliamps. Limit excess
current draw to 16 amps or less, using an
associated circuit breaker or other such device.
Never operate the printer in a location where
operator, computer, or printer can get wet.
Personal injury could result. The electrical
security of the printer is based on the reliability
of the mains power source.
1. Place the printer in a location that allows easy
access to all sides. The printer should never be
operated while resting on its side or upside
down.
2. Place the printer's power swith in the OFF (0)
position.
3. Insert the power cable into the printer power
socket and attach to grounded electrical socket
of the proper voltage and type.
4. Attach interface cable to printer and computer
and then secure.
5. Switch power on.
CAUTION : Intermittent or unpredictable
operation may occur from unsecured
connectors. If damaged, the power cable must
be replaced by an exact equivalent.
P310 i Plastic Card printer