Yamaha RX-V670 - Manual (Page 25)

25
REMOTE CONTROL “LEARNING” FUNCTION
The keys on this remote control transmitter can be programmed to “learn” key-functions from other remote control transmitters. By
using this feature, this unit can then be used in place of one or more other remote control transmitters, thus making operation of
your various audio and video components more convenient. Use the included user program sheets to indicate a new function
learned for each key.
Note
There may occasionally be instances in which, due to the signal-coding and modulation employed by the other remote control
transmitter, this unit will not be able to “learns” its signals.
1
2
3
4
5
Notes
● When you operate the desired component with this remote
control transmitter, TRANSMIT/LEARN indicator will flash
steadily.
● The originally preset function of a key is still available in the
USER position if a new function has not been learned to the
key.
● Successful learning to a key results in the erasure of
previously learned functions and their replacement by the
newly learned ones.
● If there is no more room in the memory area for a function to
be learned, the TRANSMIT/LEARN indicator will flash two
times. In this case, even if some keys are not occupied with
functions from other remote control transmitters, no further
learning is possible.
Memory back-up
All of the learned functions will be retained while you replace
the batteries. However, if no batteries are installed for a few
hours, the learned functions will be erased and will have to be
learned again.
Blank keys (Refer to page 23.)
These keys have no preset functions and are used only for
learning other remote control transmitter’s functions.
YPC-USER-LEARN switch (Refer to page 23.)
YPC: Set to this position when using preset key functions
(for controlling this unit and/or YAMAHA
components).
* “YPC” is the abbreviation of YAMAHA Preset
Code.
USER: Set to this position when using “learned” key
functions.
LEARN: Set to this position when learning new key functions
from other remote control transmitters.
RESET button (Refer to page 23.)
Press this button to “reset” the internal microcomputer which
controls remote control operations. Microcomputer “reset” is
necessary when the remote control freezes.
* Pressing the RESET button will not erase learned functions.
To Learn a New Function
Set to “LEARN”.
Press a key on this unit where a new function will be
learned.
Press and hold the key (on the other remote
control transmitter) where the desired new
function is.
When the TRANSMIT/LEARN indicator stops illuminating,
the learning is finished.
Repeat the step 2–3 unit all desired funfunctions are
successfully learned.
Set to “USER” .
Try operating your components.
This unit
About 5–10 cm
(2–4 in.)
Other remote control transmitter