Zenith R50W47 - Manual (Page 14)

14 Projection TV
Operation
SETUP
VIDEO
AUDIO
TIME
OPTION
LOCK Prev.
Select antenna input,
press
MENU
- Automatically finds all channels available through the antenna and cable sources, and stores them in memory on the channel list.
- Run EZ Scan again after any Antenna/Cable connection change.
1. Press the menu button and then use D / E button to select the SETUP menu.
2. Press the G button and then use D / E button to select EZ Scan .
3. Press the G button and then use D / E button to select antenna input (Based on your connections to antenna 1-2).
• Analog/DTV Air:
Watching Over-the-air, cable, and digital over-the-air signals via antenna 1 input jack.
• Analog/DTV Cable:
Watching Over-the-air, cable, and digital cable signals via antenna 1 input jack.
• Analog+DTV Air (ANT2):
Watching Over-the-air, and cable signal via antenna 1 input port and the digital over-the-air signal via the antenna 2 input jack.
• Analog/DTV Cable (ANT2):
Watching Over-the-air, and cable signal via antenna 1 input port and the digital cable signal via the antenna 2 input jack.
* Cable Service Band Note: Select Std=Standard, HRC=HRC Band, or IRC=IRC Band.
(For further band information, contact your cable service provider.)
4. Press the enter button to begin the channel search.
Allow EZ Scan to complete the channel search cycle for TV, CATV, and DTV/CADTV.
EZ Scan (Channel Search) EZ Scan (Channel Search)