Zenith R50W47 - Manual (Page 29)

Owner’s Manual 29
Programming the Remote
G
The remote control is a multi-brand or universal remote control. It can be pro-
grammed to operate most remote-controllable devices of other manufacturers.
Note that the remote control may not control all models of other brands.
Programming a code into a remote mode Programming a code into a remote mode
Programming the Remote Programming the Remote
1. Test your remote control.
To find out whether your remote control can operate the device without programming,
turn on the device such as a VCR and press the corresponding mode button (VCR)
on the remote control. While pointing at the device, test the power and ch+/- buttons
to see if the device responds properly. If not, the remote requires programming to
operate the device.
2. Turn on the device to be programmed, then press the corresponding mode button on
the remote control.
3. Press the power and mute buttons simultaneously, the remote control is ready to be
programmed for the code.
4. There are two ways to find the right code for the component.
A. If you press the ch +/- buttons repeatedly, the codes will change one at-a-time.
Press the power button after each code change. If the right code is found, the
device will turn off.
B. Enter a code number using the number buttons on the remote. Programming code
numbers for the corresponding device can be found on the following pages. Again,
if the code is correct, the device will turn off.
5. Press the exit button to store the code.
6. Test the remote control functions to see if the component responds properly. If not,
repeat from step 2.
1 2 3
4 5 6
7 8 9
0
tv vcr cable dvd sat
mode light power
tv/video comp/dvi front
freeze signal ratio
dash(-) flashbk
mute surf
audio video
vol ch
pip input pipch- pipch+ pip
info timer cc swap
menu exit
record stop pause
rew
play
ff
skip