Zenoah G5000AVS - Manual (Page 28)

28
8. Operation
English
4. While holding the saw unit securely on the ground,
pull the starter rope vigorously. (F8)
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch your
body. It's very dangerous.
5. When engine has ignited first, pull the throttle lever
slightly to return the choke knob to the open position
and pull the starter again to start the engine.
6. Allow the engine to warm up with the throttle lever
pulled slightly.
Keep clear of the saw chain as it will start rotating
upon starting of engine.
■ CHECKING OIL SUPPLY
Make sure to set up the bar and the chain when
checking the oil supply.
If not, the rotating parts may be exposed. It is very
dangerous.
After starting the engine, run the chain at medium
speed and see if chain oil is scattered oft as shown in
the figure. (F9)
(1) Chain oil
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch side.
Adjust according to your work conditions. (F10)
(1) Adjuster
The oil tank should become nearly empty by the time
fuel is used up. Be sure to refill the oil tank every time
when refueling the saw.
NOTE
WARNING
WARNING
WARNING
F9
F8
F10