Zenoah G5000AVS - Manual (Page 42)

42
10. Maintenance
English
Maintenance, replacement, or repair of the
emission control device and systems may be
performed by any non-road engine repair
establishment or individual.
Before cleaning, inspecting or repairing your unit,
make sure that engine has stopped and is cool.
Disconnect the spark plug to prevent accidental
starting.
■ MAINTENANCE AFTER EACH USE
1. Air filter
Dust on the cleaner surface can be removed by
tapping a corner of the cleaner against a hard surface.
To clean dirt in the meshes, split the cleaner into
halves and brush in gasoline. When using compressed
air, blow from the inside. (F22)
To assemble the cleaner halves, press the rim until it
clicks. (F23)
2. Oiling port
Dismount the guide bar and check the oiling port for
clogging. (F24)
(1) Oiling port
3. GUIDE BAR
When the guide bar is dismounted, remove sawdust in
the bar groove and the oiling port. (F25)
(1) Oiling port
WARNING
F25
F22
F23
F24