3M D-2400 - Manual (Page 11)

3M Model D-2400 Programming the System
7
Programming the System
Program the system to conform to your planned configuration and desired operation.
Hardware (Jumpers)
Select Call Station(s) to receive ALL CALL and music/messaging during STANDBY mode. (A closed jumper
turns ALL CALL and music/messaging OFF. An open circuit jumper turns ALL CALL and music/messaging ON.)
1. Use the appropriate jumper to select ALL CALL and music/messaging for each call station.
2. Jumpers JP1 through JP8 (in order) on the Main Board apply to Call Stations 1 through 8; jumpers JP9 through
JP16 (in order) on the Expansion Board apply to Call Stations 9 through 16.
The locations of the jumpers are shown in Figure 6.
Figure 4. Communications Controller Jumpers