3M D-2400 - Manual (Page 16)

Programming the System 3M Model D-2400
12
A value (Off, 1 to 16 inclusive). Priority station #, always moves to top of
queue.
On or Off. Enables the 30 second station connection time out. Default = On.
Assignment of station names 01 through Max Stations where xx indicates
station #. Default = PUMP # xy, xy = station #.
Command to synchronize all Selectors with the data in the Controller and the
Selector that issued the command.
This confirmation message follows the above. Selectors must be On Line to
be synchronized.
Read from Selector & Controller. Selector and Controller software revision
numbers.
Re-Initializing the
Selector To re-initialize the Selector to its original factory settings:
1. Remove Power to the Selector.
2. Press the ALL CALL key.
3. Apply Power to the Selector.
4. Release the ALL CALL key.
5. Confirm the re-initialize procedure by pressing the TALK key. (To abort,
press the STD BY key.)
6. Remember to adjust all of the parameters so that the Selector functions
properly in its given installation.
07:Priority{Off}
S=xx: User Name
08:Auto Standby
09:Station Name
S=xy: User Name
10:Sync All Data
‘T A L K’ = Yes
Are You Sure ?
‘T A L K’ = Yes
11:Software Rev.
Se=a.bc Con=x.yz
Initialize All ?
‘T A L K’ = Yes