3M D-2400 - Manual (Page 15)

3M Model D-2400 Programming the System
11
Error Message
The system will display one error message: No Communication.
The message occurs when there is no communications between the Selector
and Controller. To correct this:
1. Be sure Controller is powered on.
2. Be sure pins 2 and 3 of J22 on the Controller are connected to pins 2 and
3 of J8 on the Selector. Polarity must be correct.
Parameter Selection Memorized parameters are given below. These parameters are stored in the
EEPROM. The 16-character by 2-row LCD displays the parameters.
A number (1 to 15 inclusive). Default = 15. This Number must be unique
relative to all other Selector ID numbers used in the system.
A number (1 to 16 inclusive). Total number of Call Stations in the system.
Default = What the controller senses. Stations are numbered starting with 1
up to this value.
Selector. A number (1 to 15 inclusive). Default = 08.Adjusts the volume of the
alert tone (Chime or Beep). A value of 15 is the loudest setting.
Beep or Chime. Default = Chime.
On or Off. Default = Off. Enables the VOX (Voice Activated Transmission)
feature
A number (1 to 15 inclusive). Default = 15 (most sensitive).
! E R R O R !
NO COMMUNICATION
01:Selector ID #
{01}
02:Max Stations
{16}
03:Alert Volume
{08}
04:Alert Type
{Chime}
05:VOX Enable
{Off}
06:VOX Sensitive
{15}