Set qos dscp-to-cos-map – 3Com WXR100 3CRWXR10095A User Manual
Page 180
180
C
HAPTER
6: Q
UALITY
OF
S
ERVICE
C
OMMANDS
set qos
dscp-to-cos-map
Changes the internal QoS value to which MSS maps a packet’s DSCP
value when classifying inbound packets.
Syntax —
set qos dscp-to-cos-map
dscp-range cos level
dscp-range
— You can specify the values as decimal numbers. Valid
decimal values are 0 to 63. To specify a range, use the following
format: 40-56. Specify the lower number first.
cos
level
— Internal QoS value. You can specify a number from
0 to 7.
Defaults — The defaults are listed by the display qos command.
Access — Enabled.
History —Introduced in MSS Version 4.1.
Examples — The following command maps DSCP values 40-56 to
internal CoS value 6:
WX1200# set qos dscp-to-cos-map 40-56 cos 6
warning: cos 5 is marked with dscp 63 which will be
classified as cos 7
warning: cos 7 is marked with dscp 56 which will be
classified as cos 6
As shown in this example, if the change results in a change to CoS, MSS
displays a warning message indicating the change.
See Also
set qos cos-to-dscp-map on page 179