3Com WXR100 3CRWXR10095A - Manual (Page 436)

436 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Usage — You can configure the transmit power of a radio on the same
command line. Use the tx-power option.
This command is not valid if dynamic channel tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the channel on the
802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 channel 36
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
„
display ap config on page 364
„
set ap radio tx-power on page 441
set ap radio
link-calibration Configures an MAP radio to emit link calibration packets, which can aid
in positioning a Mesh AP.
Syntax —
set ap ap-number radio {1 | 2} link-calibration
mode {enable | disable}
„ ap ap-number — Index value that indentifies the MAP on the WX.
„ radio 1 — Radio 1 of the MAP.
„ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„ mode enable — Enables link calibration packets for the MAP radio.
„ mode disable
— Disables link calibration packets for the MAP radio.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 6.0.